Code Corporation Code Reader 2.0 Manuel d'utilisateur télécharger pdf (Page 18)

C001537_18_CR2_User_Manual 12

Save Settings

RS-232 Factory Default Settings

Mode: RS-232 One Way Mode

Baud Rate: 57600

Stop Bits: 2

Data Bits: 8

Parity: None

1.6.4 - RS-232 (Serial) Cable Installation Guide

1. Attach the RS-232 (Serial) Cable to the CR2.

2. Connect the RS-232 (Serial) cable to a serial port on the computer (Figure 1.19). There is no need to power off the

computer.

3. The RS-232 (Serial) interface has an optional 5V/1.5A power supply (Figure 1.20). If you have a power supply, plug the

power supply adapter into the RS-232 (Serial) cable and then plug the power adapter into a wall socket (Figure 1.21).

4. Once properly connected, the CR2 will power on and beep.

5. For RS-232 (Serial) mode scan M418_02 (below). If the power supply is not connected scan M074_02 (below).

6. Scan the Save Settings Code (M188_02).

RS-232 (Serial) RS-232 (Serial) Mode

Factory Reset No Power Supply Save Settings

Warning: Code Corporation approved power adapter must be used. Reader failure due to use of incorrect

power adapter will void warranties.

Figure 1.20

Figure 1.19

Figure 1.21

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 66 67

Pas de commentaire

Code Corporation Code Reader 2.0 Manuel d'utilisateur Page 18